CCTREE 15PCS 3D Printer Heating Block Cotton with Kapton Tape Hotend Nozzle Heat Insulation Cotton for Ultimaker/Makerbot/Creality CR-10
Note: this product only suitable for 3D printer using indoors
Attention: Small parts, keep away from children
15PCS x 2mm heating block cotton
1PCS x6mm Kapton Tape
1.3D printer replacement parts, Always shut off power to the circuit before starting installation work.
2.The surface temperature of the 3D printer might be high, and be careful not to touch the heating element to prevent injury.
3.3D printer initial operation, Do not run the equipment Unattended state.
4.When printing with a PLA(190°C-230°C) or ABS(230°C-250°C)consumable, if the temperature sensor and other accessories fail, it may cause high temperature hazards. Do not run the equipment Unattended state.
5.To ensure the users will use the product safely and properly, Please read your 3D printer manual first and follow the instructions step by step before using the product.
6.Due to the variety of possible end-uses, it is ultimately the responsibility of the customer to determine a product’s suitability for a particular application.
- Heat preservation, keep the printer heating evenly and work better
- You can Punch Holes or Cut fit size to the cotton.
- Recommend Safe Working Temperature : ＜300°C
- Cotton Size: 70mm x 20mm x 2mm Kapton:Width 6mm, Lenght:33M
- Package including:15PCS x 2mm heating block cotton + 1PCS x 6mm Kapton Tape