Kweiny Heat Insulation Cotton and PTFE High Temp Tape for 3D Printer Makerbot Hotend Heater Block | 10PCS Cotton and A Roll of Tape for Extruder Parts Tool Kit

Notice:
1. After replace the nozzle, Please recalibrate the distance between nozzle and build plate to ensure the quality of print parts;
2. Please do not use flame to test their heat resistance, because the flame’s temperature is much higher than 300 degrees Celsius (572 Fahrenheit ).

Size:
Heat insulation cotton: Length 80mm/3.15in, width 20mm/0.78in, thickness 2mm;
PTFE high temp tape: Total length 10m/32.8ft, width 8mm, thickness 0.13mm

package including:
10PCS heat insulation cotton;
One Roll of PTFE High Temp Tape

Product Features

  • Compatibility: Matches all 3D print extruder heater block offered from E3D Makerbot, MK8 Makerbot RepRap , etc.
  • High temperature resistance: Both PTFE tape and heat insulation cotton, short term resistance to temperature 260 degrees Celsius (500 Fahrenheit ), long term resistance to temperature 300 degrees Celsius (572 Fahrenheit )
  • Function: Keep heater block temperature constant, so that improving the quality of the printed matter, save electricity and prolong the service life of heater and temp sensor
  • Use-method: You can cut cotton into the right size and hole according to your needs, then stick it firmly with PTFE tape. 5 sides of heater can be wrapped up in cotton, except the surface installed heater wire, but you just need to use 1 piece cotton. You can also use PTFE tape to stick any other parts on your 3D printer
  • Material: The heating insulation cotton is made from heat resistant ceramic fiber, the tape is made from PTFE

Visit The Website For More Information…

2 comments

Leave a Reply

Your email address will not be published.