Category Archives: 3D Printing Accessories

3D Printed Octopus Magnet, Blue

This funky home accessory is great a great addition to your fridge or other magnetic surfaces. Octopus measures about 3.5 inches arm to arm, and 1 inch in tall. Made with a super strong rare earth magnet for durable staying power. Product Features Measures 4 inches arm to arm and 1 inch high Made with a super strong, rare earth magnet attached securely on back Super fun fridge magent or office accessory Made out of High Quality ABS Plastic, replicated on our desktop 3D Printers and finished […]

Read more

3D Printer Gopro Limit Kite Surfing Kitehero Kite Line Mount Gopro Kite Line Fixed Seat

Fashionbox 3D Printer Gopro Limit Kite Surfing Kitehero Kite Line Mount Gopro Kite Line Fixed Seat 3D Printer GOPRO Kitehero Kite Line Mount Gopro kite line fixed seat Please note: these item are produced by 3D printer, The surface of the product would not be very smooth, if you can not accept that and want one perfect item, please do not order. Product Features Kitehero Kite Line Mount Detailed Information available on our Homepage…

Read more

RioRand(TM) RepRap Mega 2560(Arduino compatible),RAMPS 1.4,Stepstick Pololu A4988 Stepper Driver for 3D Printer,Prusa Mendel,MakerBot

1.RAMPS 1.4 It is a Mega Pololu Shield, or RAMPS for short,designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platform and has plenty room for expansion. The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion. Additionally, a number of Arduino expansion boards can be added to the system as long as the […]

Read more

3D Printer Hot End Heater Resistor for Jhead and Other Hot Ends 2pcs

2 Pack of Heater Resistors for RepRap Hot Ends This is used in all J-Head hot-ends from Mk I to Mk V and can be used in your home made hot end. May work in other hot ends. Check your specs. Dimension: 0.217″ Dia x 0.500″ L (5.50 mm Dia x 12.70 mm) Sale is for two (2) resistors Product Features Pack of 2 resistors 5.6Ohm, 5W, 1% Perfect for your reprap hot end. This is used in all J-Head hot-ends from Mk I to Mk V […]

Read more

Tontec A4988 RepRap 3D Printer Arduino Stepper Motor Driver Carrier Module Board

Product Description A4988 is a complete microstepping motor driver with built-in translator for easy operation. This product is available in full, half, 1/4, 1/8 and 1/16 step modes operate bipolar stepper motors, output drive capacity of up to 35 V and ± 2 A. A4988 includes a fixed off-time current regulator, the regulator in slow or mixed decay modes. A4988 converter is the key to the easy implementation. As long as the “step” input inputting one pulse drives the motor one microstep. There are no phase sequence […]

Read more
1 190 191 192 193 194 197